Snow Melt System

Increased Efficiency in a Snow Melt System

Note: Installation instructions and illustrated drawings are recommendations only, while proper local construction methods are the responsibility of the installer.

For the Do-It-Yourselfer, Reflectix® has a product that enhances the performance of a Snow Melt System installed in a Concrete Slab; our specially designed Concrete Slab Insulation product. The addition of this product into a Snow Melt Concrete project will result in a higher level of energy operating efficiency. The bonus characteristic to this product is how easy it is to handle and install.

Benefits

Reduces annual energy costs of the system
Reduces heat loss due to groundwater
Installs quickly and easily
Non-toxic / non-carcinogenic
No nesting characteristics for insects

Installation Instructions

Installation Instruction pdf: PRO Snow Melt – CSI Revised 022024

Unroll the Reflectix® Concrete Slab Insulation product over the base material prior to pouring the concrete.
Butt the seams of the product and seal with 3” wide poly tape. Note: Utilize a flat edge taping tool to assure good adhesion on all tape.
Install Snow Melt System per manufacturer’s specifications.

Important

Review These Important Safety Guidelines Prior to Installation:

ALWAYS check local building codes before installing Reflectix®.
ALWAYS use eye protection.
Please Note: The intention of these Installation Instructions and 3-D renderings are for the sole purpose of illustrating the correct location and relative position of the Reflectix® products in specific building assemblies. The correct construction methods and techniques are the responsibility of the installer or contractor. The methods outlined are recommendations on location of the Reflectix® products as a guideline. There are no claims on the part of Reflectix, Inc. that these building assemblies are finite standards or meet building code requirements (as they can vary by region).

Testing and Certification

Reflectix® products are thoroughly tested at either nationally approved, independent laboratories or leading universities. Tests are performed to current American Society of Testing and Materials (ASTM) standards when a standard exists. To obtain a copy of our Product Testing Specifications, please refer to the “Additional Resources” tab. The documents are also available by e-mail at customerservice@reflectixinc.com or call (800) 879-3645.